contax_shooter
10-22-13, 20:24
Purchased a new Gen 4 17 and noticed this while I was doing an inspection at home. I compared it to my Gen 3 19 and it does not share this characteristic. Test fire dated 09/10/13
Seems like the area indicated shows support rails for the slide not being completely covered by Glock during the molding or something. The same thing is on the opposite side as well.
http://farm4.staticflickr.com/3751/10431294696_1a16c1fe3b_b.jpg
http://farm4.staticflickr.com/3691/10431263434_b2301e7c4f_b.jpg
http://farm3.staticflickr.com/2866/10431286085_cd4baf0bbe_b.jpg
Is this something I should worry about?
Seems like the area indicated shows support rails for the slide not being completely covered by Glock during the molding or something. The same thing is on the opposite side as well.
http://farm4.staticflickr.com/3751/10431294696_1a16c1fe3b_b.jpg
http://farm4.staticflickr.com/3691/10431263434_b2301e7c4f_b.jpg
http://farm3.staticflickr.com/2866/10431286085_cd4baf0bbe_b.jpg
Is this something I should worry about?