PDA

View Full Version : Which Sight Pusher for Glocks w/ 10-8 and/or Trijicon rear sights?



RAM Engineer
06-27-09, 21:21
I have a Glock 19 with Trijicon sights installed. I just bought a new Glock 19 and a set of 10-8 brass bead sights I'd like to install. Can anyone recommend a good sight pusher that would work with the 10-8s and hopefully would also work with the Trijicons, should I need to adjust them in the future?

Thanks in advance,

Jason

Jason Burton
06-28-09, 01:49
Forget the sight pusher... I've never found any of them to work all that well. The best thing for moving or removing sights (especially tightly fit sights) is a sturdy vise, a wood punch, and a hammer.

tpd223
06-28-09, 06:01
I've installed hundreds of night sights with a hammer and brass punch, no sight pusher needed.

Robb Jensen
06-28-09, 09:35
I have a Glock 19 with Trijicon sights installed. I just bought a new Glock 19 and a set of 10-8 brass bead sights I'd like to install. Can anyone recommend a good sight pusher that would work with the 10-8s and hopefully would also work with the Trijicons, should I need to adjust them in the future?

Thanks in advance,

Jason

For removing or installing the factory or Trijicon and Mepro night sights the genuine Glock sight tool works. The Glock sight tool from MGW works well too. For installing 10-8, Novak, Warren or Heinie sights use the MGW tall Glock sight tool.

RAM Engineer
06-28-09, 20:26
For removing or installing the factory or Trijicon and Mepro night sights the genuine Glock sight tool works. The Glock sight tool from MGW works well too. For installing 10-8, Novak, Warren or Heinie sights use the MGW tall Glock sight tool.

Is this the MGW Tall tool you are referring to?

http://www.lonewolfdist.com/Detail.aspx?PROD=1222

Thanks guys,

Jason

Robb Jensen
06-28-09, 20:28
Is this the MGW Tall tool you are referring to?

http://www.lonewolfdist.com/Detail.aspx?PROD=1222

Thanks guys,

Jason

Yep that's it. In stock and a little cheaper here: http://www.topgunsupply.com/sight-adjust-install-tool-glock-tall.html

RAM Engineer
06-28-09, 20:36
Ooo...Thanks! A new place to spend my money!