FWIW my PSA order placed on 11/28 arrived today.
Printable View
Finished a pistol build.
Anderson lower; Velocity 3# trigger, KAK brace, H buffer.
Anderson upper; BCM BCG, BA nitride 1/7 5.56 barrel, BCM KMR rail and mod O comp.
Installed a cheapo PA 2 min. red dot- as I've had good look with these previously. The mount is a PA full co-witness for use with BUIS- which I've yet to install.
I have Troy BUIS that I didn't get installed as I wanted to dial in the RD first.
Inforce WML.
I do like the WML mounted below the barrel.
Shoots quite well to 200 yds, which is farthest I've had a chance to shoot it. No trick to keeping all hits in A/C zone at 200 with a rest.
http://i1043.photobucket.com/albums/...ps8dvugicv.jpg
http://i1043.photobucket.com/albums/...pswk4lfuzv.jpg
Just installed mine today. I think it is the best looking brace. Will find out how it performs at the range Friday.
I've been using one on my MPX for a few months. The Sig brace that came with it was wider and the KAK folds up nice and tight. Comfort wise, the top strap loop is annoying, but not bad enough to make me want to do anything about it. The KAK tube threaded in just a tad too far so the brace insn't timed perfectly straight. Again, not bad enough for me to want to do anything about it. On an AR, it wouldn't matter since you lock it into position with the castle nut.
If this protector cap gets approved by the BATF, I will finally have a reason to buy a shock Wave instead of a Sig Brace
https://www.ic13arms.com/shop/sbp-pi...race-protector
I wonder how close a "brace" can be made a "stock" before the BATF calls foul...