Dead Air Key-Mo Stuck Muzzle Device
'Sup fellas. So I've decided to replace my SiCo Trifecta muzzle devices and the MAAD mount on my Saker with the Dead Air Key-Mo system. Everything seemed to be GTG with regards to mounting and removing the suppressor. However, I did not necessarily go through the whole routine of timing the brake, or torquing it down to spec with a dose of Rocksett. As a result, when I went to remove the suppressor from the rifle it was mounted on I ended up unthreading the muzzle device. While the suppressor is off the gun I'm having a very hard time removing the muzzle device from the Key-Mo mount. I've tried heating it up to see if I couldn't get it to work loose, but the muzzle device is still stuck in the grip of the Key-Mo. Works a little too well I guess. I'm thinking maybe I could apply some Rocksett or maybe some red Loctite onto the threads, thread the brake and suppressor back on, let it cure overnight and then see if it sticks enough to allow me to break it free. Anyone run into this problem? Any recommendations, solutions, or ideas are welcome. Thanks.
ETA: Disregard. I fixed it.
http://imagizer.imageshack.us/v2/102...924/3chpiX.jpg