Don't really know. I would say that it would be similar to the URX II/BCM build we have going.
C4
Printable View
This can be a reason, but 90% of the time it is because the weapon is short stroking.
I have mags with high end CS springs. It does not make a difference.Quote:
2. Have you tried the Wolff extra power/+P mag springs, in an attempt to get the bolt to lock back 100% of the time, even when unsuppressed???
It would be simply amazing if this setup worked 100% reliably EVEN WHEN UNSUPPRESSED. ????
The 10.5 has ALWAYS run 100% without the can on and so far the 11.5 does as well.
C4
The NP3 finish, like a lot of the other ones wears off over time. The fail zero finish is actually into the metal as they buy the BCG's in the white.
The sole purpose for me using the fail zero stuff was to try and run a lube less, suppressed weapon (something the world has never really seen before).
What I am thinking about now is buying LMT Enhanced carriers (in the white) and sending them to fail zero to have coated.
C4
I know that you cannot actually double the pressure generated by round, but the felt recoil does feel as if you are shooting a much larger caliber.
I still remember the first time I shot a suppressed 416 10.5. I had to look down and make sure that it was not chambered in 6.8 or 7.62X39.
Until this 11.5 project, I failed to fully realize how much force a can generates. When you can go from a cut down SS buffer spring wtih a car buffer and NOT GET THE WEAPON to cycle (not lock back) and then add a suppressor and go all the way up to an over sized CS buffer spring and H3 buffer and have it lock back with force, you know that something is up!
C4