M&P45 6004's on the shelves yet?

[Robb Jensen]

Does an M&P 9mm specific 6004 work with the M&P .45?

My 6005 for a M&P9 works with a M&P45. It took some force to get it to go all the way in. I then used a heatgun to heat up the muzzle end and wala it works just fine now but the muzzle sticks out a little.

[VA_Dinger]

I've been calling around all week trying to find a M&P45 6004 in stock to use at a class next week with no luck. Does anybody have any leads?

Stephen

PM sent.

[MEANGREEN]

There is a good chance that Safariland might have these in stock.

I ordered one (M&P .45 w/SF X300, Right Hand, Coyote Tan) directly from them and got it a week ago after a month's wait. I'm not sure how they run their
special orders, but I doubt they'll only make one and not run a batch through.

Good luck.

[Resq47]

Update...

I wound up buying a NIB G21 6280 to get going and found it fit very well. Put the calipers on the slides of my MP45 and a bud's MP9c and found they are equal width as well, keep this in mind MP'ers...

So, happy with the 6280 but not super huge on 2.25" belts I ordered up a 6004-10 shroud...resulting in a couple week backorder (again). I shot the MP45 from the 6280 over the weekend and confirmed it's a good match.

Today I get a ship confirmation on the 6004 I ordered 3/15...

On the positive side I'll be able to compare the proper version to the G21/M3 setup