Q: I possess a properly registered SBR or SBS. I intend to strip the receiver and remove the barrel prior to selling the receiver. Is the bare receiver still subject to regulation under the NFA as a SBR or SBS?
A stripped receiver without a barrel does not meet the definition of a SBR or SBS under the NFA. Although the previously registered firearm would remain registered unless the possessor notified the NFA Branch of the change, there is no provision in statute or regulation requiring registration of a firearm without a barrel because its physical characteristics would make it only a GCA “firearm” pursuant to 18 U.S.C. § 921(a)(3)(B). If the subsequent owner buys the receiver as a GCA firearm and installs a barrel less than 16 inches in length (SBR) or 18 inches in length (SBS), the firearm would be subject to a $200 making tax and registration under the NFA by the manufacturer or maker of the SBR or SBS. Because registration depends upon the stated intent of the applicant, there is no provision to allow registration of a NFA firearm by anyone other than the maker or manufacturer.
Q: If I remove the short barrel from the registered SBR or SBS, is the receiver still subject to NFA transfer and possession regulations?
If the possessor retains control over the barrel or other parts required to assemble the SBR or SBS, the firearm would still be subject to NFA transfer and possession regulations. ATF recommends contacting State law enforcement officials to ensure compliance with state and local law.
Q:
Does the installation of a barrel over 16 inches in length (SBR) or 18 inches in length (SBS) remove the firearm from the purview of the NFA? If so, is this considered a permanent change?
Installation of a barrel greater than 16 inches in length (SBR) or 18 inches in length (SBS) will remove the firearm from the purview of the NFA provided the registrant does not maintain control over the parts necessary to reconfigure the firearm as a SBR or SBS.
Q:
If I remove the short barrel from my SBR or SBS, may I move the firearm across state lines without the submission of ATF Form 5320.20, Application to Transport or to Temporarily Export Certain Firearms?
If the registrant retains control over the parts required to assemble the SBR or SBS, the firearm is still be subject to all requirements of the NFA. ATF recommends contacting law enforcement officials in the destination state to ensure compliance with state and local law.
Q:
May the short barrel on an SBR or SBS be replaced with a long barrel for hunting or other purposes, with the intent of replacing the short barrel?Yes, and you will not be required to again register the firearm before replacing the short barrel. ATF recommends written notification to the NFA Branch when a firearm’s configuration is permanently changed or removed from the purview of the NFA.
Q:
May I transfer the receiver of a short-barrel rifle or shotgun to an FFL or to an individual as I would any GCA firearm?
Yes. A weapon that does not meet the definition of a NFA “firearm” is not subject to the NFA and a possessor or transferor needn’t comply with NFA requirements. The firearm is considered a GCA firearm and may be transferred under the provisions of that law.
Bookmarks