I'm setting up my dies and I think I got them ready to go. I'm using a Dillon 550 and haven't set my powder charge yet. Just getting everything else set. I'm using a Remington 115g FMJ RN http://www.midwayusa.com/product/252...-bulk-packaged
After resizing the case width is 0.375.
After flaring the flare width is 0.390.
After bullet seating the OAL is 1.105.
After crimping the width is 0.376 at the crimp. It's 0.377 just below the crimp.
Do these numbers look good? I'm going to be using IMR SR4756 and CCI 500 primers to start because that's all I could find that was in my reloading manual.
Bookmarks