Finally finished this last night, and got to zero it this morning. This rifle is intended for ringing steel at 400-600 yards, or further, from prone. I'm not much of a benchrest shooter. I've also never had a serious precision oriented rifle, so I built this one without skimping out. At the same time I saved quite a bit of money over purchasing a complete Noveske rifle by being patient and waiting for sales on new and used parts.
Upper:
Vltor MUR-1A
Noveske 18" medium contour SPR barrel with intermediate gas
Noveske pinned gas block
Noveske NSR 13.5" handguard
BCM BCG
BCM Gunfighter mod 4 charging handle
Nightforce NXS 2.5-10x32
Nightforce Ultralite Unimount
Lower:
Noveske Gen 2 Chainsaw
Noveske QD end plate
Vltor A5 receiver extension, rifle spring, and A5H2 buffer
Geissele G2S trigger
G&R LPK
Magpul MIAD grip
B5 Enhanced SOPMOD stock
I'm not overly concerned with back up sights, but I may throw an offset MRDS or Aimpoint Micro on. It will be fed a diet of Nosler 77gr custom comps thanks to the advice and help of a few reloaders on M4C.
Bookmarks