CZ P-07

[shrewd yasu]

It doesn't come out too good...?
Are you saying the retention is stronger? If so, that's not really a problem

[Magsz]

As it stands there is no blue gun for the gen 2 or 2014 model P07's so most garage based kydex makers are using the older duty mold.

When it comes to holsters...never assume, always ask first.

There shouldnt be any fitment problems between the two models unless the mold in the first place was poorly made.

[Alpha Sierra]

I have a KT Mech Gunfighter (.060 material) and a gen 2 P-07. The only problem I have is that the front serrations scrape a little plastic off the inside of the holster every now and then.

[Chipper78]

I have a KT Mech Gunfighter (.060 material) and a gen 2 P-07. The only problem I have is that the front serrations scrape a little plastic off the inside of the holster every now and then.

That is exactly what is happening with mine, it's so tight that when I try to draw it pulls the entire holster out. I will contact KT Mech today and see what they say. I will also try and post some side by side pics of the differences in the slides.

[Alpha Sierra]

it's so tight that when I try to draw it pulls the entire holster out.

My holster was NEVER that tight, even right out of the box. If you did not specify level 3 retention on your order, you really need to call KT Mech.

[Chipper78]

Yea, emailed them and they have offered to take to let me send it back on their dime to tweak it or give me a full refund. Very fast responce to my email and customer service seems to be really good.

[Tomahawk_Ghost]

Tell me this, where are you guys finding spare mags for these pistols?

[m4brian]

I do think using the flatter P09 nine trigger in the Gen 2 P07 is a great thing.

[Chipper78]

Tell me this, where are you guys finding spare mags for these pistols?

CZ USA website had some last time I looked.

[Chipper78]

Here are the pics I promised.
view from the top, duty model on the left, you can see the angles on the slide of the duty model are much sharper.
photo 3.jpg
Another view from the top, again duty model on the left. In this pic you can really see the difference in the slide that was causing the fit issue with my holster.
photo 2.jpg
In this pic the gen two is on the bottom, hopefully in this pic you can see the three ridges in the magwell of the gen two. The duty model magwell is totally smooth inside.
photo 1.jpg
This pic shows the difference in the beavertail, duty model on the left. The softer angles on the slide and shorter beavertail are supposed to make it more comfortable for concealed carry.
photo 2-1.jpg