Gas Block Help

[Ryno12]

It's drilled to BE pinned. Not yet pinned as I have to install the barrel nut.


Sent from my iPhone using Tapatalk

Gotcha. The pic I saw, it appeared to be already pinned.

I was gonna suggest a 3' pipe wrench with a 6' cheater might get it to move.

Sent via Tapatalk

[lahunter57]

Gotcha. The pic I saw, it appeared to be already pinned.

I was gonna suggest a 3' pipe wrench with a 6' cheater might get it to move.

Sent via Tapatalk

Let me get right on that!


Sent from my iPhone using Tapatalk

[mpom]

That barrel should be a tack driver, with good ammo.

[lahunter57]

That barrel should be a tack driver, with good ammo.

That's what I'm hoping for. The barrel is far more capable than I am, but it's a tool that I'm excited to work and learn with. Once I get it built I'll post it up.


Sent from my iPhone using Tapatalk

[Gravedigger]

As long as the ion is in and the port hole in the barrel matches the one in the block you are golden my friend. Looks done properly as I just did one myself.


Sent from my iPhone using Tapatalk

[Gravedigger]

And if you want to remove the block out some oil on the barrel around the block and try to twist it. If you just wanna see if they are aligned just use a paper clip


Sent from my iPhone using Tapatalk

[LewP]

My Rainier SS Medcon looks exactly the same. There's a small gap between the barrel "shelf" and the body of the gas block. Works just fine. Go shoot it.