Looks a little snug on the cantilever, but the MBUS Pro screw isn't actually touching, you've just got to be at the right angle to tell. I think this paints the Offset mount in a bad light actually, as the Cantilever puts it so low that it gives the appearance that the Offset mount is sticking out a lot further than it is. In reality, the M-LOK surface would bisect the light if you drew a line straight up. I'm a terrible photographer, but I tried to get a representative view of each in one pic but it's a little off. Anyways, the offset mount is made to support optics as well as clear lasers in certain configurations but it still tucks the lights in out of the way. It also mitigates issues clearing iron sights with an offset light that the cantilever in a 45-degree M-LOK slot might pose. Naturally I think everyone should use MBUS Pros, but if you use a larger front sight you should clear most of them with the Offset mount. Of course, we can't accommodate every possible configuration so in the future a very tiny OD handguard with a large sight may pose issues regardless of the offset mount used, be it ours or another M-LOK manufacturer.
IAW site rules, I work for Magpul Industries
This is a personal account and the opinions expressed may not reflect those of Magpul Industries
Bookmarks