Even getting the scope as low as possible, you will still probably need a cheek riser. I used the Bell & Carlson Sendaro / Varmint / Police Medalist Style 1 Remington 700 Short Action Rifle Stocks 2958 BDL with a Tac-Pro cheek riser;
Even getting the scope as low as possible, you will still probably need a cheek riser. I used the Bell & Carlson Sendaro / Varmint / Police Medalist Style 1 Remington 700 Short Action Rifle Stocks 2958 BDL with a Tac-Pro cheek riser;
EDC Light Builder | No Nonsense Everyday Carry Flashlights
"Air Force / Policeman / Fireman / Man of God / Friend of mine / R.I.P. Steve Lamy"
If you use Buttler Creek style caps and they touch the barrel it will effect accuracy. How much wont be known until you shoot it but it does make a difference. If you have air gap between scope and caps you are probably OK
I shoot target for a 5" X ring at a 1000 yards so I error on side of caution on these things and open channel and gaps so I don't have to worry. That is for extreme accuracy. My medium range ( 800 and in)sniper rifles have enough gap between barrel and stock so I can clean channel with bandana but then I wrap them with cloth so reflextion
Now for my 400 yards and in hunting rifles if they shoot 1 moa I am happy and I tend to wrap the barrel and stock with camo cling to keep reflection down.
Depends on use/target what you can get away with. Just check before hand and see what you get
In that photo, that gap is way too much for me. As others have said, you should use as low a rings as possible without touching the barrel, accounting for caps if you use them.
Formula: http://forum.snipershide.com/snipers...correctly.html
The scope, which has a 42mm objective in a 30mm tube (vs. a 50 or 56mm objective in a 35mm tube) gives the illusion the scope is mounted high. The scope is sitting in low Seekins rings on a 15 MOA Leupold steel base. It was among the lowest combos I could find using a 1-piece 15/20 MOA base and the Seekins rings (which IMO are excellent).
The actual clearance between the scope objective bell and barrel is about .3" at the narrowest point;
EDC Light Builder | No Nonsense Everyday Carry Flashlights
The gap between scope and barrel above is how mine looks with a 50mm objective. I ended up getting the B&C A2 stock and it helped but with getting lined up behind the scope. The low rings are definitely going to get me the rest of the way. So my follow on question is this; is there any advantage either way with going Nightforce direct mount one piece base or two piece rings and base? One piece seems like one less thing to go awry.
What is the contour of your Remington Barrel and what picatinny mount are you using? If its an MTU contour you can get away with 1 inch or even .875 rings if you running a 50mm objective.
"This setup is too high for a good cheek weld and general comfort while prone. "
stock pack and shim it... that that hard to fix....
I just received some Vortex low rings in the mail yesterday, the ones Seekins makes, so I am going to find out soon enough how they'll work. Got some Nightforce Medium Ultralites for sale shortly
Bookmarks