BCM gas block removal/ADCO

[bjw182005]

Well Im sure if anyone would know It would be you. Ill order some and give it a shot. You know if any major retailers carry it?

I am very familiar with how that block was installed. I also know what Loctite they use. Uncure breaks down cyanoacrylate which is the active ingredient in Loctite. I have used this stuff for about the last 6 months and it has yet to not work for me. YMMV

[Singlestack Wonder]

I would certainly like to see BCM start supplying LPGB's in a taper pinned configuration as they do on their 18" SPR's and short KINO offerings. A single taper pin is very effective (and easily removable). When I'm doing a build requiring an LPGB, I always go with a Daniel Defense barrel with LPGB.

[Iraqgunz]

Nope. I ordered it from Amazon and waited the 2-3 days for it to arrive.

Well Im sure if anyone would know It would be you. Ill order some and give it a shot. You know if any major retailers carry it?

[Iraqgunz]

There's no need to as evidenced by this thread. Wanna guess how many Noveske and similar single pin blocks I have seen people destroy with a hammer and punch?

I would certainly like to see BCM start supplying LPGB's in a taper pinned configuration as they do on their 18" SPR's and short KINO offerings. A single taper pin is very effective (and easily removable). When I'm doing a build requiring an LPGB, I always go with a Daniel Defense barrel with LPGB.

[Onyx Z]

No need to use crazy heat and stuff. Get this and follow the instructions. If it doesn't work, do it twice. I use it all the time and it works. YMMV

http://www.amazon.com/Bob-Smith-161-.../dp/B0000DD1QS

I wonder if that stuff works for Rockset...

[Singlestack Wonder]

There's no need to as evidenced by this thread. Wanna guess how many Noveske and similar single pin blocks I have seen people destroy with a hammer and punch?

Probably a lot as most try to do it without proper tools or training. For those with experience, not an issue.

[Singlestack Wonder]

I wonder if that stuff works for Rockset...

Warm water works for Rockset.

[Onyx Z]

Warm water works for Rockset.

That's what I've heard.. but have yet to try it.

[Iraqgunz]

I don't believe Rocksett contains cyanoacrylate.

I wonder if that stuff works for Rockset...

[Iraqgunz]

Hot water. I put water in a pot and boil it. Hold the muzzle device in there for about 5 minutes or so and then throw it up in the vise. You can also soak it in hot water for longer if you don't mind standing around.

That's what I've heard.. but have yet to try it.