My goal on this build was to be as light as possible while still maintaining top quality and accuracy. It will be used for 3-gun competition. The feed ramps on the barrel have been polished, the receiver face has been trued. Loctite 609 sleeve retaining compound was used at receiver to extension and gas block.
Upper Receiver:
Voltor MUR 1 w/out FA
Noveske LW/ NST 18" intermediate 1:7 416R
Syrac adjustable gas block dimpled with 3/16" end mill
V7 Furion titanium comp w/ Precision Armament accu-washer
JP enhanced bolt w/ Colt ejector spring and rubber
JP low mass carrier, buffer and spring
15" BCM KMR w/V7 titanium bbl nut
Noveske marked Raptor ambi charging handle
NightForce Unimount
Vortex Viper PST 1x4x24 MRAD w/ home made throw lever
Lower Receiver:
2A Armament Balios-Lite lower
Lancer carbon fiber A1 stock
Hammer forged 7075-T6 A1 buffer tube (Colt)
Hogue Exteme G10 grip w/V7 titanium grip screw
V7 titanium buffer retainer
V7 titanium take down and pivot pins
Phase 5 Tactical EBRv2 w/.010 shim
BAD-CASS-SA-ST ambi safety selector
Hoplite Defense titanium mag release w/Odin XMR-2 button
Hoplite Defense titanium anti-rotate trigger pin system
All springs and detents are Colt
The trigger is a Geissele SSA-E until I can find a SD-3G in stock somewhere.
Bookmarks