Can't get DD Gas Block Taper Pin to Budge!!!!

[trauma]

I bought 3 DD barrels with LPGBs and they all came with those short pins, I replaced them with some regular midway ones.

[556BlackRifle]

I remember my first set of taper pins. Now I have a torch, bigass punch and hammer.

Congrats on getting the KMR installed. Now get it out and shoot it!!

[m4fun]

Stable surface and BFH every time. Heat only for non-upper body days

[lahunter57]

Success! BCM KMR13 installed!
Attachment 32444

How was it getting that barrel nut off? I've got a V7 and I'm thinking about switching out the MFR


Sent from my iPhone using Tapatalk

[Scout Actual]

I bought 3 DD barrels with LPGBs and they all came with those short pins, I replaced them with some regular midway ones.

So do you just have your pins sticking out on either side now?

[Scout Actual]

How was it getting that barrel nut off? I've got a V7 and I'm thinking about switching out the MFR

Removing the MFR was easy. I did buy the special DD MFR Wrench from Midway for $10.

[Scout Actual]

I remember my first set of taper pins. Now I have a torch, bigass punch and hammer.

Congrats on getting the KMR installed. Now get it out and shoot it!!

I'm going to recheck my zero at the indoor range today during lunch!

[SteveL]

Bumping an old thread here but which way did you have to drive that pin out?

ETA: you remove it left to right. And it was a BITCH.

[dramabeats]

Bumping an old thread here but which way did you have to drive that pin out?

ETA: you remove it left to right. And it was a BITCH.

to get the barrel nut off?

[SteveL]

to get the barrel nut off?

Yes. I was changing the handguard.