Noveske Gen III lowers

[billybronco]

Any encountered or heard any reports of magazine incompatibility (IE-not seating fully or locking up in magwell)? Bout to build this thing out and if I encounter a similar issue as one of my earlier lowers, I'ma blow a ****in gasket.

Thanks.

[Iraqgunz]

I may be wrong, but as I recall Gen III lowers below a certain serial number had issues. I'm sure you can search for it here.

Any encountered or heard any reports of magazine incompatibility (IE-not seating fully or locking up in magwell)? Bout to build this thing out and if I encounter a similar issue as one of my earlier lowers, I'ma blow a ****in gasket.

Thanks.

[sidewaysil80]

I believe it was only the Gen II lowers that experienced mag incompatibility. I have a Gen III that seats/releases old G.I. Mags and the latest Pmags with no issues.

[Iraqgunz]

Maybe so. I am sure he could search for the thread to confirm.

I believe it was only the Gen II lowers that experienced mag incompatibility. I have a Gen III that seats/releases old G.I. Mags and the latest Pmags with no issues.

[og556]

My early Gen II was not compatible with Magpul M3 mags due to the over insertion stop on the back of the magazine IIRC. I forget the S/N range that was effected by this but after a certain period the gen 2's and I believe all gen 3's should work with the Magpul m3 mags.

[sidewaysil80]

According to this thread it was the early Gen II lowers that experienced hiccups. Apparently the later Gen II's were corrected and run problem free. Serial numbers affected/summary below:

https://www.m4carbine.net/showthread...with-Magpul-M3

[Gatorshark]

I'm running a late Gen III. no mag problems with GI or magpul.