Ran into a G mount issue. Not compatible with my K16i. Mounted it up at 18 in-lb (within G and Kahles spec), and noted that the ring halves touched ("closed solid") on both sides. There was only 0.01" gap to start with on both sides. Used feeler gauges, Wheeler tq wrench, and micrometer. Scope tube measured 29.97mm. The only thing I can think of as off is the G mount, as my previous G mounts have started with 0.015-0.018" of clearance before tightening began. This is what happens when you machine things like so. Increased chance of failure secondary to tolerances. Replacing the G-mount with a Badger tomorrow. Super sad, this thing was pricy and it was a PITA to level the scope and get everything ready, only to torque it correctly and discover it was FUBAR. At least there are ZERO marks on my K16i from it.
Bookmarks