Yup. That's correct.Originally Posted by scottryan
|
||||||||||||||||||||||||||||||||||||||
Senior Member
Yup. That's correct.
Member
A stripped lower fits a in a small USPS flat rate box nicely.
Senior Member
According to Ident since it's a firearm being shipped for repair an individual can ship it direct and receive without FFL.
Must you declare it a firearm with USPS is my biggest question. Just tell them it's a firearms receiver?I try to avoid that if possible.
Last edited by Zane1844; 10-13-15 at 20:15.
- cqbdriverIt is from the construction of underground FEMA camps. I can't say more because there a guy parked in front of house in an AMC Pacer. He is acting like he talking on the phone, but I know better.
I have to sign off now & put my laptop in the microwave.
Senior Member
..and a stock. Or so I'm told in this thread.
I'm not fat, I'm tactically padded.
Tactical Commander Fast Action Response Team (F.A.R.T.)
Member
Received my lower back from tar heel and they did a great job. I didn't realize how small the ATF minimum size is.
Member
I've had several done at Grey Laser, always nice work and fast turnaround.
Member
I don't think it was mentioned, but Tar Heel State will engrave it in the trigger guard area without removing the trigger guard. They turned mine around in one day and were also cheaper than the other options I looked at. I would definitely use them again.
Member
To add, they also do this without ANY disassembly. I have only great things to say about them.
Senior Member
What size did they do? Because there's not a minimum. I'm going to guess they did 1.6mm
Member
I guess you're right, the only minimum is for serial number. They did 1/16 of an inch, which is as you said 1.6mm for them. Not a complaint, just an observation. Work was 100% good to go.
Posting Permissions
Reply With Quote
Bookmarks