Gen2 InForce WML & WMLx Review

[Tomac]

Used to own several of the Gen1 WMLx's, all of them cracked where the bezel screws into the body. While Inforce replaced them promptly, I lost trust in the durability of the design.
This Gen2 WMLx has sufficient improvements that I'm going to try a couple of them again (fingers crossed).

Tomac

[Run N Shoot]

I was all set to grab a gen 2 xml through the PA sale earlier this week but they went fast! Still on the lookout for any sales since this is the light I am set on.

[Benito]

Anyone now how to mount this at a 45 degree angle so it's at 10-11 or 1-2 o'clock?

If using a KMR, would a pic rail section work on the angled flat work, i.e. would there be enough clearance between the light body and the top rail?

If using an NSR (no angled flats) is there some offset adapter rail that would work?

Thanks, and great review, Mr.G&G