off facebook...
off facebook...
Whoever appeals to the law against his fellow man is either a fool or a coward. Whoever cannot take care of himself without that law is both. For a wounded man shall say to his assailant, "If I Live, I will kill you. If I Die, You are forgiven." Such is the Rule of Honor.
The CGW trigger is out. It looks a lot different than the prototype.
Do you even get down innagrass, bro?
That is interesting. My issue with the factory trigger is the curve of the trigger face makes the safety the high spot on the trigger. That wears a blister in my finger after a few hundred rounds. I would hate to spend $68 and find that the CGW trigger does the same thing. David
I'm positive that's been addressed by CGW. I'm going to wait a while and at least see if there are any other kinks they need to work out, though.
What I did to fix the safety dingus on my factory trigger is I took about a 1/2" wooden dowel and wrapped some fine sand paper around it. Then I gently sanded the dingus down a slight radius until it was flush with the trigger face. You'll see if you press against it with something the areas you need to take material off. It doesn't take much since it's polymer.
Do you even get down innagrass, bro?
Yes I did the same sanding on my factory trigger. I have always done it on Glocks also. I have a HBI trigger in my P10C now. It’s one of the early ones with the fangs on the bottom. I wish I would have waited for the current version. David
Bookmarks