Knight's Armament stripped lowers coming soon
Originally Posted by
556BlackRifle
Could someone please point me in the direction to the solution for the KAC trigger guard not fitting on these lowers? I searched but couldn't find any specifics.
Thanks!
A couple of options.
1. Contact KAC, they are coming out with a new KAC trigger guard that's supposed to work. When KAC informed me of this 2 weeks ago, they were approximately 4 weeks out. (Still in QC as I understood). Support-wise, they have been pretty responsive to me.
2. Get your Dremel or in my case I used my cordless drill to expand the trigger guard pin hole a little. Afterwards the roll pin still secured in the lower if that's a concern. I can probably figure out what size drill bit I used if that will help. I secured the trigger guard in my vise, using some magnet polymer 'covers' on each jaw of my vise to protect the trigger guard. I eyeballed it and made sure my drill was level and drilled the hole out. Just slightly larger than it is now. It worked easy peasy after that.
Let me know if you want that drill bit size. I'll try to find it.
"Texas has yet to learn submission to any oppression, come from what source it may."
~ Sam Houston
The liberties of our country, the freedom of our civil constitution, are worth defending against all hazards: And it is our duty to defend them against all attacks.
~ Sam Adams
Bookmarks