Once I've out of scrap, they'll probably be 1" hex. After controlling my depths better, the 22mm is sufficient but 1" hex stock is a lot cheaper and more readily available. 1-1/8" is overkill
Nate
NAAH Tool Works
Naahtoolworks@gmail.com
Once I've out of scrap, they'll probably be 1" hex. After controlling my depths better, the 22mm is sufficient but 1" hex stock is a lot cheaper and more readily available. 1-1/8" is overkill
Nate
NAAH Tool Works
Naahtoolworks@gmail.com
im in.. keep us posted Nate
Got enough material on hand to make 35 or so. Soon as my beta tester reports back it's full steam ahead.
Nate
NAAH Tool Works
Naahtoolworks@gmail.com
Awesome
Had some variability in dimensions between adapter manufacturers. Revised wrench out for testing.
Nate
NAAH Tool Works
Naahtoolworks@gmail.com
Just got my prototype in mail & tested it on my Griffin Armament 3-lug MD. The fit was great & wrench worked awesome.
Mine is a 22mm but my understanding is that Nate will be using slightly larger 1" stock going forward.
If you're looking to mount a 3-lug adapter to your barrel, this is a great tool to have.
You're also supporting a member of M4C & Nate is a good guy too. Buy with confidence!
Thanks for the good word my man.
Plan is to use up the little bit of 22mm stock I have then switch to 1". I don't think anyone here has emailed me so I'll probably be long out of 22mm before I get to yall.
Nate
NAAH Tool Works
Naahtoolworks@gmail.com
Yall tell me if you think this is worthwhile. I was just fooling around a minute ago and tried some surface hardening on one of my first pieces.
Nate
NAAH Tool Works
Naahtoolworks@gmail.com
And this is the first no lie production piece, with all the chamfers, reliefs etc a tool is supposed to have
Nate
NAAH Tool Works
Naahtoolworks@gmail.com
Bookmarks