My GAP HRT arrived a couple is months and and I'm finally starting to beak-in the barrel (optic on back order). At the range yesterday I noticed this defect in the stock under the cheek raiser:

IMG_2529.jpg

Perhaps I'm being too critical, but this hole exposes the screw that holds tension on the raiser. I'm very tempted to send it back over this issue alone, and am not getting a good vibe from the accuracy. Granted, I'm shooting single shots and cleaning between each, but the first 10 rounds were spread over 3.5". That is shooting from a rest with a NF ATACR in BO rings. Of note, no test target came with the rifle.