Grant,
Did you have any probs of compatability with the Vltor Mur upper and the Larue rail?
Also, what about the Mur not fitting a standard upper receiver block?
Thanks in advance!
Grant,
Did you have any probs of compatability with the Vltor Mur upper and the Larue rail?
Also, what about the Mur not fitting a standard upper receiver block?
Thanks in advance!
not grant, but figured i could answer. the anti-rotation plate/key (as grant mentioned above) needs fitting to the MUR receiver.
when i installed a larue rail on a MUR, i cut off the right side of the anti-rotation key as it's the left side that keeps the rail from loosening.
if you use a DPMS 'claw' receiver block, it fits inside the receiver, so the outside profile doesn't matter.
MM,
Thanks.
On a recent one I did, not only did the locking plate need milling modification,
but I also needed to reduce the head diameter of the twin locking screws.
End result was just fine.
MM is correct. I use the DPMS receiver block with the MUR (works just fine). For installation of the LT locking keys, I hand grind each one to fit and then shoot it with KG coating.Originally Posted by alias
C4
Thanks!!!!!
If these MUR uppers become common, I'll get a DPMS block.
Bookmarks