I've been chasing loads for years, and I'm finally ready to just settle on a few. But I have a couple more factors in the equation to ponder, neck tension and crimping... Is a full length sizing die going to do anything for neck tension? And is a light crimp going to do anything to remedy varying tension? I'm beginning to think some, but not all of my vertical stringing is a result of this.
At this point I'm settling on three loads, two for accuracy, one for speed and fragmentation...
A Varget load works well, as does markm's h322 house load. I had actually found the h322 load in the past, but discounted it for its lack of velocity.
And an AA2520 load for fragmentation, pictured below(25.1), in a 10 round test shoot. This is also where I seem to keep seeing at pesky stringing. I'd really like to find something with a higher velocity, all the while keeping all 10 under an inch.
Anyhow, thought I'd stop by, ask and share.. thanks for reading.
Attachment 45468
Bookmarks