Gas Port Data

**Furbyballer** · 08-07-18, 05:38

Perfect so far with a vltor spring and a5h0 with wolf gold, men 556, and imi 77grain unsuppressed.

Originally Posted by archad

How does in function?

Sent from my SM-G892U using Tapatalk

Sent from my SM-G950U using Tapatalk

**WS6** · 08-07-18, 06:13

Originally Posted by Furbyballer

Perfect so far with a vltor spring and a5h0 with wolf gold, men 556, and imi 77grain unsuppressed.

Sent from my SM-G950U using Tapatalk

Would it run with an A5H2 or a carbine RE and H?

**Furbyballer** · 08-07-18, 06:16

Originally Posted by WS6

Would it run with an A5H2 or a carbine RE and H?

Not sure yet. Only had limited time at the range and only ran it on an a5 lower since that is what i have on all my guns. Will experiment with the other buffer weights and my suppressor next time im out.

Sent from my SM-G950U using Tapatalk

**WS6** · 08-07-18, 06:24

Originally Posted by Furbyballer

Not sure yet. Only had limited time at the range and only ran it on an a5 lower since that is what i have on all my guns. Will experiment with the other buffer weights and my suppressor next time im out.

Sent from my SM-G950U using Tapatalk

Do you think it would have run the Wolf Gold on a heavier buffer/stiffer spring, or likely not, just guessing based on how it ran? What g as block did you go with?

**Furbyballer** · 08-07-18, 06:28

Probably, as my experience with wolf gold is that it seems to shoot much more like 556 m193 than 223. I started at this point since im still struggling to find the solution to get my hodge 14.5 to run unsuppressed. I use bcm gas blocks since i have a dimpling and pinning jig for it.

Originally Posted by WS6

Do you think it would have run the Wolf Gold on a heavier buffer/stiffer spring, or likely not, just guessing based on how it ran? What g as block did you go with?

Sent from my SM-G950U using Tapatalk

**WS6** · 08-07-18, 06:29

Originally Posted by Furbyballer

Probably, as my experience with wolf gold is that it seems to shoot much more like 556 m193 than 223. I started at this point since im still struggling to find the solution to get my hodge 14.5 to run unsuppressed. I use bcm gas blocks since i have a dimpling and pinning jig for it.

Sent from my SM-G950U using Tapatalk

So this runs with more authority than the 14.5? what did your 14.5 pin-gauge at? Have you checked BCG/gas-key integrity?

**Furbyballer** · 08-07-18, 06:34

Originally Posted by WS6

So this runs with more authority than the 14.5? what did your 14.5 pin-gauge at? Have you checked BCG/gas-key integrity?

Yes and yes. Im at the point know where im concerned the shop that put together the rifle for me while i was traveling didnt center the gas block enought. Im going to tear it down and rebuild and gauge the gas port. Using a brand new sionics np3 bcg in it. I think the 14.5 midlength hodge is even more conservatively ported than their 12.5in barrels. But i should have more info thid weekend.

Sent from my SM-G950U using Tapatalk