Well I guess I don't know my own strength but I somehow pulled the rear takedown pin all the way out!!! The detent pin was still in and didn't go flying into no man's land. That is, until I was messing with it and then it came out (talk about hunting for a needle in a haystack).
I was actually trying to figure out how to get the detent pin back in and also the takedown pin WITHOUT having to loosen the staked castle nut and back plate.
I did manage to get the detent back in several times (and have it pop out several times) but couldn't figure out how to get the takedown pin back in with the detent pin in the channel like it's supposed to be.
I decided to go ahead and buy a castle nut wrench and remove it and install the rear takedown pin (and spring and detent) the normal way but then my stubborn streak reared it's ugly head
I managed to get the detent back in then used an eyeglass screw driver to push it all the way back into the receiver.......while it was pressed in I inserted a CHOPSTICK through the back hole into the hole with the detent and once the chopstick was in I pulled out the screw driver. So now I have the detent pushed in most of the way and the chopstick inserted. Next I pushed the chopstick so that the detent was once again all the way in and placed my rear takedown pin flush with the chopstick (with the channel NOT towards the detent) and moved them TOGETHER AT THE SAME time until my rear takedown pin was in and the chopstick was out. Next I turned my takedown pin until the detent clicked into place ...........SUCCESS, and I avoided having to remove the staked castle nut. I do believe I can do this again if need be (hardest part may have been to get in the detent again, it's so very small and slippery).
Some may ask why I just didn't do it the normal way to begin with. Well, first, I'd have to buy a castle nut wrench, probably a vice or something to hold the receiver, I didn't really want to break free the "pinned" castle nut and have to re-do that........and I was just being stubborn in thinking that there had to be another way to get that darn detent and pin back in!!! Plus the more I take apart and try to "fix" the more I sometimes mess something else up....LOL
I actually sort of got the idea from a video where they were replacing the rear takedown pin without removing the castle nut....but in their scenario, the takedown pin was still installed so it was pretty easy to do. I guess in the end, the only thing I did different is use a smaller diameter rod (my chopstick) so it would fit in with the screwdriver yet still be able to push the detent in all the way and then slide out when I tried re-inserting the takedown pin. So I certainly don't take any credit for the "methodology", I'm just glad I got it to work the way it did.
So, this has been a learning experience for me. And you can be sure I'll NEVER pull that pin all the way out again!!!!!!!!!!!!!
Ended on a high note as I successfully installed a new safety without any incidents.
Bookmarks