Lewis Machine and Tool MRP ejection port cover removal?

[INTrooper4255]

I am pretty sure that you tap the forward roll pin up and that will allow the ejection port cover rod to come forward and then swing out from the receiver. You should then be able to tap it back into place without issues.

Ok, that's what it looked like, I just wanted to be sure. Thanks

[Jwknutson17]

I am pretty sure that you tap the forward roll pin up and that will allow the ejection port cover rod to come forward and then swing out from the receiver. You should then be able to tap it back into place without issues.

This is correct. You only drive out the forward pin and it that's all you need for removal. Did one a few months ago. No issues.

[INTrooper4255]

This is correct. You only drive out the forward pin and it that's all you need for removal. Did one a few months ago. No issues.

Perfect, thanks all!

[INTrooper4255]

I tapped the front roll pin out and the dust cover fell right out. Thanks guys