nevermind
nevermind
Last edited by Doc Safari; 06-07-18 at 09:23.
This sounds to me to be eerily similar to the Remington 700 problems years ago. I'll make a point of asking Iraqgunz about this in a couple weeks when I take his class. Are these lowers ending up out of spec somehow?
To me, that not the same. This only happens when in between positions. Usually the force it takes to overcome the detent causes the selector to "spring" forward. I would think for the selector to be between positions, something is wrong, or it was deliberately done. That being said, I have never flipped one from semi to full.
Sent from my SM-S327VL using Tapatalk
You, and everyone else, are completely correct. I see clearly the error of my original thoughts on this. I got hung up on the idea, possibly incorrectly, that this issue came to light when folks were deliberately putting the selector in an inappropriate position with a "hold my beer, watch this" mentality, and couldn't get past that.
Last edited by LMT Shooter; 06-06-18 at 12:00.
So I read this article and the plethora of follow on write ups and come away with...
1. Troop pulls the trigger when the selector is between semi and auto. Nothing happens.
2. Troop then switched to semi or auto and gun discharges.
3. This does not occur from safe to semi (or in between).
4. Eight to ten percent of tested rifles are affected indicating tolerance/maintenance issue versus the mythical "design flaw," no?
5. Once this hit the interwebs and the seeds of panic were sown....well, everyone in my agency has tested their semi-only rifles. 0% malfunctioned from safe to semi. Tested my two personal rifles. Same thing.
Definitely something to address but not the doomsday scenario pushed initially by some writers. Is there an additional PMCS step after this initial pass/fail or is a pass at this stage GTG?
As far as I know, just follow the new function test, plus new adjusted Immediate Action Drill. If you haven't, scroll down the the following link.
https://www.armytimes.com/news/your-...-m4s-and-m16s/
Wasn't it not firing when between positions when the trigger was pulled but then when the selector was on semi or auto, it fired without pulling the trigger---or do I have this wrong? If it fires without pulling the trigger this sounds like a broken selector AT LEAST. My AR won't do this.
Bookmarks