What should I do with this?

[LOKNLOD]

...Besides give it away, that is.

This little puppy showed up in the mail today:


I've got some ideas for a build...but am still up in the air on it. Anybody got suggestions? That IDF thread has a lot of ideas in it...

[Akoni]

K.I.S.S. build w/11.5" would be my vote. What upper is that?

[USMC03]

Something that I'm just finishing, utilizing an A1 upper:

-A1 upper with round (A2) foward assist and XS same plane rear apeture

-14.5" M4 barrel with Colt M4 handguards and Sabre Defense long A2 flash hider

-LMT Lower with Vltor Carbine stock and Tango Down Battlegrip


Light, handy, short, was a fairly inexpensive project, no NFA, no bells, no whistles, no BS. Something I can teach new shooters with, use as a truck gun, etc.



Semper Fi
Jeff

[LOKNLOD]

Jeff,
I like where you're going with that.

I remember seeing at one point a A1-uppered Midlength with a Magpul stock, in coyote, that you posted up. Still got that rifle? I remember it being pretty slick.

Akoni,
Sounds good but unless somebody wants to donate to my tax-stamp fund...probably a no-go. ETA: It's a Bushmaster.

[Robb Jensen]

Just give it to me. I'll give it a GREAT home!

[adh]

maybe this

[LOKNLOD]

I really like that.

I'll end up with one of three setups:

14.5" M4 barrel w/ perm attached, M4 stock like adh shows.
16" Midlength (matches my primary rifle), M4 stock.
M4-profiled Dissipator barrel and fixed stock (Sully or A1). For some reason I really dig this one...

A pencil barrel like this one from the IDF thread would be neat as well (maybe I can get the wife into a IDF uniform...grrr )

[deadwood83]

I like adh's set-up. Just switch the M4 contour with a pencil barrel and that would be my choice for an A1 upper.

And if all else fails i'm sure the UPS man could help me help you

[Glockster35]

I like the looks of ADH's rifle, but would probably add one thing. A SureFire M500A to it.

Speaking of which, I need to find one of those SureFires and get started on this as my next upper project...I have everything else, but the A2 upper receiver...although I do have two orignial flat side upper receivers waiting to be used...


Humm...the choices this forum brings to me!

[USMC03]

Jeff,

I like where you're going with that.

I remember seeing at one point a A1-uppered Midlength with a Magpul stock, in coyote, that you posted up. Still got that rifle? I remember it being pretty slick.

I sold the the mid length you are refering to, in order to fund another project. But I miss it a lot, so started a new A1 project. I wanted something lightweight and compact. Thus I went with the 14.5" M4 on the A1 upper.

Just waiting on the bolt carrier group and charging handle to be delivered and it will be a complete.