Results 1 to 10 of 18

Thread: Removal of Trigger Guard?

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Join Date
    Feb 2009
    Posts
    2,481
    Feedback Score
    2 (100%)

    Removal of Trigger Guard?

    I am trying to install a Magpull Miad Grip and trigger guard to my N4. I am realizing that trying to remove the roll pin from the existing trigger guard might not be a just "go for it" process. So, is there a specific punch (size, #, shape,material?) technique (support method) to removing it with out breaking the receiver trigger tabs? After I get it started out do I drive it "all the way thru?" or as it comes out one side do I then grab it with a needle nose pliers and pull? I'm really trying not to have a failed surgery on my new N4

    Any tool suggestions that I might need for minor adding and subtracting on my rifle would be appreciated.

  2. #2
    Join Date
    Feb 2007
    Location
    SE Idaho
    Posts
    1,741
    Feedback Score
    50 (100%)
    "It is better to be a Warrior in a Garden than a Gardner in a War"
    Let's use the First Amendment to protect the Second so we can avoid using the Second to protect the First.

  3. #3
    Join Date
    Feb 2009
    Posts
    2,481
    Feedback Score
    2 (100%)
    I swear I did several searches...I just did it again to see if I'm a special needs forum member and evidently I am Thanks

    I'm going to try and find a AR gunsmith in Denver area tomorrow. If I snap it off I'll be ticked for a year

    Any recommendations?

  4. #4
    Join Date
    Oct 2008
    Posts
    148
    Feedback Score
    0
    First, soak the existing installed roll pin in CLP.

    Then, follow Magpul's easy instructions with a small hammer and a 1/8" roll pin punch available from Sears. Do not re-use the original roll pin.

    Tap slowly, and the oil will be your friend. Use needle-nose pliers for re-inserting the new roll pin, which you should oil heavily prior to installing.

  5. #5
    Join Date
    Feb 2009
    Location
    CNY
    Posts
    8,465
    Feedback Score
    12 (100%)
    I had to beat the snot out of the pin in my LMT lower to get it out. I think they used some kind of loc-tite or something similar.

  6. #6
    Join Date
    Feb 2008
    Location
    Florida
    Posts
    1,432
    Feedback Score
    0
    I wish I knew about that roll pin punch kit before a few days ago when I had to pop out the trigger guard for my MIAD... I almost ruined my punch trying to get that sumbitch out. Anvil Arms LPK in a Superior Arms lower receiver = TIGHT spaces.


    -B
    RIP, Jeff Dorr: 1964 - July 17, 2009


    "When young men seek to be like you, when lazy men resent you, when powerful men look over their shoulder at you, when cowardly men plot behind your back, when corrupt men wish you were gone and evil men want you dead . . . Only then will you have done your share." - Phil Messina

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •