How did you get the Punisher Skull on your lower?
Originally Posted by
Hawkeye
As promised, here are some new pics. I am extremely pleased with how this project turned out. Here is also a breakdown on the parts.
* CMT M4 upper
* CMT BCG
* CMT charging handle with PRI big latch
* CMMG 14.5" light weight 1/7 midlength barrel with perm. attached phantom fs & F front sight base
* CAV arms handguards
* Midwest Industries short picatinny rail mount
* Surefire X200A
* Troy rear sight
* Samson cantilever Aimpoint mount
* ML3 4moa Aimpoint
* Spikes Tactical lower
* Stag/CMT lower parts kit
* KNS pins (not shown in pics)
* Magpul MIAD
* CMT receiver extension
* Magpul CTR
* Vickers sling
* CProducts SS mag w/ Lumpy plate
Just a couple of thoughts on the Samson cantilever Aimpoint mount. I REALLY like this mount. Very low profile and snag proof. All the points on the corners and such are beveled off. It is very solid. Best of all, it sits just slightly lower than other mounts. With this one, the irons are about dead center instead of the lower third as on others. This makes for some very fast target/dot alignment, but more importantly to me, even if the dot is off, using the Aimpoint itself as a giant gost ring in conjunction with the front sight works great. It works very well for good hits at 25-50 yrds. I know Pat Rogers has spoke of this before as well.
Also, the Midwest Industries mount I have the X200 on is a great piece.
"A man's country is not a certain area of land, of mountains, rivers, and woods, but it is a principle; and patriotism is loyalty to that principle."
--George William Curtis
Bookmarks