It's retained by the four screws on the bottom of the Micro. So it's a dedicated mount.
It's retained by the four screws on the bottom of the Micro. So it's a dedicated mount.
pro-patria.us
Placed an order for a SA58 carbine w/ 18" barrel and type 1 receiver sans carry handle. I was told, based upon previous orders by my dealer, that it may take about 6 months before I see it, which is not a bad thing as I need about that much time to pay for it. It will also give me time to start stocking up on mags and ammo.
Last edited by RyanS; 07-18-09 at 00:12.
I got mine (18" full stock and gas system) from this guy-great to deal with and his site shows the stock.
http://www.dsarms.com/SA58-FAL-Carbi...tinfo/SA58C18/
I had the Para, was nice, but shooting it wasn't.
My stick is slick other than a light like LAV has in the pick.
Mark
http://www.usmadefal.com/
Ok thanks to a new friend in the industry I have a prototype back. They have a long history with this stuff, so I didn't turn it out in my garage.
Intial impression I like it.
Low mount for the Micro on the FAL. It is not QD.
Please tell us more-as in where do you get it?
Last edited by mark5pt56; 07-18-09 at 07:37.
GET IN YOUR BUBBLE!
If it works out I'll see about having some more made. I might have them turn out a couple more for some of the high volume shooter SME's, dealers and industry guys to break, I'm sure they will do it before I do.
This was just a concept I wanted to try out. I have to many irons in the fire right now to do a personal production ready testing. Templer, the first ones yours if you want.
Last edited by DMR; 07-18-09 at 13:25.
pro-patria.us
I just picked this up from a buddy, slightly used....
DSA SA58 Para
18" premium barrel
Standard full length gas system
DSA Type II upper receiver
Aluminum lower receiver
FN M249 grip
DSA Para scope mount
Para bolt carrier with sand cuts
Para folding cocking handle
Buttstock tubes shortened to 9.5"
LOP is now 13.5"
DSA standard handguards
T48 trigger guard
Gemtech Quick Mount flash suppressor
Kahles 1.1-4x CSX illuminated dot scope
LaRue 1.5 qd mount
BFG VCAS sling
I'm going to attach a piece of picatinny rail to the handguards to mount a while light.
Employee of colonialshooting.com
DMR
I like that topcover.
I replied to your post about it over in the "Files"
Can you shoot me some info on possible availability/cost?
Is this the one that Mark Graham got you hooked up with?
I'm presently using the DSA setup on my carbine but would like to be able to co-witness it.
Thanks
Wes in az
Bookmarks