Results 1 to 3 of 3

Thread: KX3 Installation HELPPP

  1. #1
    Join Date
    Dec 2006
    Posts
    10
    Feedback Score
    0

    KX3 Installation HELPPP

    I lost the damn instructions so i need some help. First off, do you need a certain degree of poundage or do you just hand tighten it on the threads? Is any type of oil or Loctite needed? Thanks.

  2. #2
    Join Date
    Jun 2006
    Location
    Michigan
    Posts
    494
    Feedback Score
    0
    I'm not sure of the exact Spec's, BUT if I had to assume, you SHOULD use Rocksett over LocTite and as for the Torque Spec - no idea.

    Bottom line Check noveske Website or call.

    Sorry for the non-help
    Brett W

    Elite Defense
    Vice President of Domestic Sales and Marketing


    FN Senior Manager of Assault Weapons - SCAR Program 2006-2010
    Former Troy Industries Inc Director of Operations 2003-2006

    Each Warrior wants to leave the mark of his will, his signature, on important acts he touches. This is not the voice of ego but of the human spirit, rising up and declaring that it has something to contribute to the solution of the hardest problems, no matter how vexing!
    -Pat Riley

  3. #3
    Join Date
    Jun 2006
    Location
    VA
    Posts
    10,781
    Feedback Score
    17 (100%)
    I use the supplied crush washer and tighten until it lines up with the Noveske engraving on the left side and pig on the right. I try not to torque more than about 30ft lbs.
    Chief Armorer for Elite Shooting Sports in Manassas VA
    Chief Armorer for Corp Arms (FFL 07-08/SOT 02)

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •