Originally Posted by
Scout Rifle Archive
The Concept
The idea behind the scout rifle is not new. The famous old Mannlicher 6.5 carbine was a step in this direction, as was the equally famous Winchester Model 94 30-30 carbine. The British "Jungle Carbine" of World War II was another example of the breed, and finally there came the ill-fated Remington 600 carbines of a decade ago--excellent guns in most ways but ahead of their time. I acquired a 600 in 308 and fitted it with a Leupold 2X intermediate-eye-relief telescope. This laid the groundwork of the scout concept...
...modern technology enables us to produce a rifle which need not sacrifice either power or accuracy to convenience. The new-wave rifle is neither more powerful nor intrinsically more accurate than the rifles of the past, but it is much, much handier--shorter, lighter and quicker to operate. The current guideline is a length limit of one meter and a weight limit of three kilos. (This weight is measured with all accessories in place but with the weapon unloaded.) Immediately these limitations point us toward short actions, short barrels, compact sights, and synthetic stocks. A further feature which distinguishes the modern scout rifle from its predecessors is the telescope sight, but that in a certain particular mode. The modern scout uses a low-power telescope mounted just forward of the magazine well. In recent decades, progress in the development of telescope sights has been to a certain extent negative in that telescopes, instead of becoming stronger, smaller and faster to use have become larger, more cumbersome, more fragile and almost necessarily mounted too high above the bore...
The Forward Telescope
For those who have not tried it, an explanation of the advantages of the forward telescope is in order. First, and most important, the forward glass does not obscure the landscape. With both eyes open the shooter sees the entire countryside as well as the crosswire printed on his target. For this reason it is important that the magnification of the telescope be no greater than 3X (some hold that 2X is maximum) in order to avoid excessive disparity between the vision of the two eyes. This forward mount, properly used and understood, is the fastest sighting arrangement available to the rifleman...There are those who think that a glass of low power is necessarily less precise for long-range precision work, but we have not found this to be the case in any sort of realistic test.
There are many additional advantages to the forward telescope mount. It is out of the way when the rifle is carried at the balance. It may be mounted as low over the bore as the diameter of the bell permits. It avoids pinching between thumb and bolt handle when the bolt is operated. It permits stripper loading if desired. It greatly facilitates single-loading with eyes on target. It completely eliminates "telescope eye." Without exception, those who have tried the forward mounted glass in a full course of rifle training are unanimous in their conviction of its superiority...
Mounting
The problem of mounting a telescope properly in its forward position is severe...Since scout barrels are as thin as compatible with safety there is no way to screw anything onto the barrel at the forward telescope mount ring. Therefore some sort of extrusion must be applied to the barrel in order to provide a proper base for the front mount. On Scout I this was the plastic rib that came on the Remington 600. On Scout II a machined steel ring was slid over the barrel and sweated into place to offer foothold. On Scout III the standard Ruger quarter rib of the single shot rifle was affixed to the Ruger Ultralight to provide a forward footing. On all subsequent scouts the barrel is machined with intrinsic rings in place.
Bookmarks