I recently purchased an MGI bolt barrel and GG lower for my SBR. After assembly, I found that the rifle functioned perfectly. I was very happy until I found that at 25 yards the bullets seemed to have a mind of their own. I then shot a few rounds into phone books, and couldnt find rifling on them, although the rifling in the barrel looks fine. I then measured the barrel, and found the grooves to be about .458, and the grooves (lands, sorry) .451. This didnt seem right to me, and doesnt jibe with any of my other 45's. I sent the barrel back to MGI for them to take a look, and they said, "oh yeah, thats in spec, all of our other barrels are like that too.They sent it back, and I got it today. What do you guys think? What do I do now?
Heres a photo of a lead bullet that I pushed into the bore BY HAND
Heres same bullet from muzzle end:
And here are some measurements:
Bookmarks