S&W M&P15 Mid MOE w/ Aimpoint PRO & Hogue stock
S&W M&P15 Mid MOE w/ Aimpoint PRO & Hogue stock
Last edited by Harrier; 10-17-15 at 00:21.
Yes, It took me around 2 hours to install these handguards on this BCM upper. I pulled the front sight base off, cut off the bayonet lug and sling mount ( optional ), filed & dremeled it smooth , cold blued then high heat black painted the bare metal areas, installed the round end cap I somehow had from years ago, then reinstalled the front sight base with the gas tube still attached. I did not have
a whole lot of trouble installing the handguards, but they do fit real tight. I filed just a little bit off the inside, inside rear corners of the bottom handguard where the corners hit the delta ring and it seemed to help some getting it to snap together. I did not use a handguard installation tool or have any help installing these, but you may. Absolutely no movement in the handguard , I like the shrouded front sight base and they feel real nice in the hand, to me.
BCM 16" lightweight middy upper on a spikes lower.
Attachment 34941Attachment 34942
Left is a 16" mid length. Right is a 14.5" mid length.
Aero P upper
Omni lower
BCM charge handle
BCM buffer tube single point QD lock ring
B.A.D. Lever
DPMS AR15 BCG
DD 6.8 SPC bolt
IMI pistol grip
ATI forend
IMI forend grip
Mission First tact buttstock
ARP helical fluted 3O Herrett 16" mid length barrel
Vortex 2x7 Crossfire Scope
Burris QD scope mount
Last edited by Sqr; 09-11-15 at 18:49.
Lightweight AR15 by John Hermesmeyer, on Flickr
Bookmarks