Colt (or equal) LPKs

[markm]

I would also strongly recommend a Type 1 hammer from SAW. These hammers don't have the slam fire notch cut in them. They are not cheap but they wear better and ride smoother. An LMT hammer would be good if you have small pins. They don't have the slam fire notch either.

Wow. I didn't know the Type 1 hammer existed. Too bad SAW is so expensive.

[Failure2Stop]

Disregard. I assumed by "bureacrat pins" you were implying .170 pins.
Apologies.

[rob_s]

I was poking around SAW after reading this thread (I too have a lower in need of guts) and stumbled accross:

Lower receiver parts kit, Colt, .155, Semi

Would this be the "Holy Grail" of LPKs? The price certainly seems to imply so.
Of course I have no idea if they are actually in stock or not.

It was referred to on page one of this thread.

The original intention of this thread was to find a company, even if not up to Colt quality and only of RRA/CMT quality, that made a complete lower receiver parts kit with the properly sized pins to fit in a Colt receiver.

Barring that, I'm still trying to figure out which actual parts/pins are affected in the Colt receiver by the different pin sizes and which parts are the same as everyone else.

[ar_mcadams]

on stag kits sometimes the fcg pins are parked and sometimes blued. I also have a dpms kit that has parked pins but got it 4 years ago.