AR Picture Thread

[Moose-Knuckle]

215 Gear makes the hat. The are a HSLD gear manufacturer. They make some SOLID gear. Not cheap, but it’s so well made. Aside from my favorite hat, they make one of my favorite ifak pouches. But you asked about the hat - so here’s the link. I’ve had mine a few years, and it’s still holding up like the day I bought it. Super lightweight also.

http://www.215gearstore.com/operatorshatelw.aspx

Outstanding, many thanks. Been looking for more breathable head gear for our summers.


Errr pic thread:

[RobertTheTexan]

Robert is that a Vltor MUR upper? I couldn't get my magpul 45 deg sights to fit correctly with my MUR, they would hit the forward assist housing and raise the rear sight up and rub on the upper.

I also had to stick with a non-ambi charging handle because my fingers couldn't grab the ambi with the 45 deg sight in the down position.

This is a pretty new build as it’s configured so I haven’t zeroed the offsets, that said, I am able to manipulate them fairly easy and they do sit flush. As I recall they seat as they normally do. As far as the CH....This build I decided to give the new BCM 4x4 a shot. It’s not as wide as the Raptors I normally run on these types of AR’s. Maybe because of that I had no issue actioning the BCG. However, if part of your training is palming the CH, that isn’t going to happen. I’m just saying the one scenario I know will not work.
I’m not full sold on the offsets, originally I ran the usual Troy BUIS, and may yet go back to the Troy’s. This first outing was more to run through different ammo with and with a can to see how it performed gas-wise and to get a quick feel for the accuracy of the CA barrel. So I didn’t run any drills flipping the sights up while the weapon was shouldered. I only did that in my shop. But I didn’t see anything to give me alarm then either.

Don’t know if these help or not..




There is enough room to get my gloved index finger on the CH for a solid purchase.


Not much of a difference, but a little.

[Kilo 1-1]

[RHINOWSO]

“So I didn’t run any drills flipping the sights up while the weapon was shouldered”

My habit pattern is to deploy offset sights as part of checking the weapon - ie, I pick up the weapon (from a case or safe, whatever), check it’s loaded or load it, then flip them up and leave them up.

[LowSpeed_HighDrag]

[TacticalFun]

Very nice

Sent from my SM-G955U1 using Tapatalk

[Voodoo_Man]

[Hammer_Man]

Deleted.

[Jonnyt16]

Just finished adding some upgrades to my new DDM4V7 in Patriot Brown. Shown with my go-to rifle, a DDM4V7 SLW.

[RobertTheTexan]

Not sure you could post a more Voodoo_Man-like Pic than that one right here bro. That things got voodoo written all over it.
Nice photo.



Sent from my iPhone using Tapatalk