I`m trying to identify an AR-15 detachable carry handle, the owner claims it`s off a Colt 6920. The only marking is a square casting mark in the upper rear right side, no letter C . I`m not sure if it`s Colt so any info will be appreciated .
I`m trying to identify an AR-15 detachable carry handle, the owner claims it`s off a Colt 6920. The only marking is a square casting mark in the upper rear right side, no letter C . I`m not sure if it`s Colt so any info will be appreciated .
When in doubt,empty the magazine.
Be sure the Square is a square and not a keyhole mark.....
If it s keyhole mark it very well could be a colt.
Also just because its a keyhole does not make it a colt. The keyhole just means cerro forging if im not mistaking.
Not all keyhole carry handles are made on Colts machines.
It`s a square, i put my glasses on to make sure.
When in doubt,empty the magazine.
The square is a square.
It is probably Colt, but to make sure you need to measure from the bottom of the carry handle to where the rear sight base sits. This should be .840"
A commerical dimension carry handle will be .800"
"Not every thing on Earth requires an aftermarket upgrade." demigod/markm
wow, wasnt aware Brass Aluminum provided colt forgings.
.840 on the dial caliper. Thanks Scottyran. So Brass Aluminum`s forge mark is a square, Thanks again. I kinda thought that Colt would have stamped a C along side of the square. I have a Cerro Forge upper with a C stamp applied.
When in doubt,empty the magazine.
Bookmarks