Pappabear
NFA Revocable Trust
Tempe AZ
Is this correct (given my correct full name)
If I have this Laser Engraved, what is the best way to refinish it? Any thoughts or feedback.
Pappabear
NFA Revocable Trust
Tempe AZ
Is this correct (given my correct full name)
If I have this Laser Engraved, what is the best way to refinish it? Any thoughts or feedback.
Id like to keep it short but it is the Pappabear NFA Rev. Trust. Kinda sucks its so long but WTF, Ill just get it done.
Consumer-grade laser engraving services generally do not meet the ATF's depth/size requirement, so I would entrust this to a company with experience in NFA engraving.
AC
I'm curious about what you would with a gun like the ACR with a polymer lower, is it possible to engrave it? If not how would you register one as an SBR? I don't have one i'm just curious.
The serial number is on the upper of an ACR. I'd engrave the upper.
"Real men have always needed to know what time it is so they are at the airfield on time, pumping rounds into savages at the right time, etc. Being able to see such in the dark while light weights were comfy in bed without using a light required luminous material." -Originally Posted by ramairthree
Ident Marking and Orion Arms both come to mind as very experienced firearms engravers. Both are 07/02 FFL, so can legally possess your SBR receiver in the event you decide to send it for engraving after it's registered (unlike the local trophy shop, where you'd have to have it done while you wait). They specialize in BATF-legal engraving (.003" deep and 1/16th inch high minimum) and blacken the lettering afterward.
http://www.orion-arms.com/
http://www.identmarking.com/index.html
Last edited by Hmac; 01-13-11 at 21:18.
Bookmarks