my daniel defense update

[fivefivesix]

heres my dd in its current form. i took of the rail and put m4 handgaurds on,along with a carry handle.
i used the rear carry handle and adjusted it for the revised improved battle sigt wic worked great. 6/3 -4 clicks and it was dead on at 50 yards. i have 2000 plusrounds through it now. in the begging i had trouble with it short stroking with tula ammo. since then i changed out the action spring and buffer for a bcm spring and buffer and cleaned my gas tube. i had carmalized grease in the gas tube.
now it eats everything i put through it. thanks m4c

[Iraqgunz]

How did grease get in the gas tube?

[fivefivesix]

i got over zealous with the tw25b grease in the upper receiver.i used it to lube the charging handle and the bcg rails. i also put some on the end of the gas tube where the gas key slides over it. live and learn. ive been using millitec and ewl since then

[Iraqgunz]

My guess is that the spring and buffer were good to begin with.

i got over zealous with the tw25b grease in the upper receiver.i used it to lube the charging handle and the bcg rails. i also put some on the end of the gas tube where the gas key slides over it. live and learn. ive been using millitec and ewl since then

[fivefivesix]

My guess is that the spring and buffer were good to begin with.

I think your right. however when i changed the buffer and spring is when i measured the gas port and cleaned the whole gun. i had to use a drill bit to clean the hardend grease out of the gas tube.what happened was i read to use a LITTLE oil on the tip of the gas tube wear it enters the gas key. so i figured grease would work better. just goes to show if a quality gun wont run certain ammos check the last things things that were dicked with.