Results 1 to 10 of 34

Thread: 300 Blackout Load Data

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Join Date
    Jul 2011
    Posts
    41
    Feedback Score
    0

    300 Blackout Load Data

    I am starting this thread to post my results of loads I try good or bad for the 300 BLK. and everyone is welcome and encouraged to add load data from there 300 Blackout load results.

    My 300 Blackout is built on a Spikes Forged Upper and Lower receiver with a RRA Chrome BCG and Wilson Combat 16" SS Match Grade Barrel.

    First I wanted to try some 110 Hornady SP Bullets. Wanted a good cheap round to shoot and even hunt with. I wanted to hopefully get 2400 FPS out of it with minimal signs of pressure and good accuracy is a must. First i just wanted to find what loads would keep me in between 2300 and 2400 FPS no accuracy test until i find the load range I have to work with. I will be doing this with almost every .308 bullet available from 110 to 165 grains and will post results on this page as I go.

    This took place on 8/4/11 at 80F and 60% Humidity

    Hogdon H110 Powder loaded in PMC .223 brass sized by Lee 300 Blackout dies over Tula NCSR-223 primers. Hornady 110 SP bullets OAL 2.00

    19 Grains. No pressure signs but a little slow rifle did cycle fine LRHO

    1. 2266
    2. 2292
    3. 2262
    4. 2253
    5. 2258

    AV. 2272
    ES. 33.78
    SD 14.59

    19.5 Grains. In the fps range I wanted no pressure signs rifle ran well

    1. 2276
    2. 2292
    3. 2281
    4. 2313
    5. 2345

    AV. 2301
    ES. 68.79
    SD. 28.21

    20 Grains. In the middle of fps I wanted rifle ran fine no pressure signs

    1. 2344
    2. 2369
    3. 2377
    4. 2360
    5. 2358

    AV. 2361
    ES. 33.15
    SD. 12.70

    20.5 Grains. Started showing signs not bad but 2400fps

    1. 2409
    2. 2391
    3. 2424
    4. 2439
    5. 2409

    AV. 2415
    ES. 47.72
    SD. 18.05

    I tried 21.5 grains but only shot one round very flat primmer it ran 2454 fps but I will pull the rest apart to hot for me :tdown:. I will load up 6 round each with 19.8, 20, 20.2, 20.5 grains of H110 they should all be above 2300 fps and see witch one holds the tightest groups.

    WARNING! SOME LOADS IN THIS THREAD MAY EXCEED RECOMMENDED CHAMBER PRESSURE FOR THE 300 BLACKOUT. DESPITE MY BRASS AND RIFLE NOT SHOWING ANY SIGNS OF EXTREME PRESSURE, YOUR RESULTS MAY VARY. IF YOU CHOOSE TO REPRODUCE THESE LOADS, DO SO AT YOUR OWN RISK
    Last edited by Edward78; 08-04-11 at 12:33.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •