New Noveske NSR rail!

[madisonsfinest]

What has you sold on the mk4 over the nsr?

I don't think there is anything wrong with the NSR. There are a few things I do like about the Geissele though. The Mk4 will have keymod as well, but they are not being produced until April. Take a look at the Geissele thread to see the differences.
https://www.m4carbine.net/showthread...light=Geissele

On a side note. I did find a NSR on rainier arms and picked it up. I will give both a shot, and go with which one I like best.

Does anyone know if the BCM LGB 750 will fit under this rail? I assume it does.

[txbonds]

Does anyone know if the BCM LGB 750 will fit under this rail? I assume it does.

Yes it will fit.

[Defender3]

FWIW - Rainier Arms has the longer NSR keymod 1913 rail sections in stock.

[Stickman]

FWIW - Rainier Arms has the longer NSR keymod 1913 rail sections in stock.

Chief, you have a chance to throw your NSR on yet? If so, what do you think?

[Defender3]

Chief, you have a chance to throw your NSR on yet? If so, what do you think?

I liked it enough to order rail sections. The Noveske felt good in my hands and I think I'll like it since I run a pretty clean rifle as far as accessories go.

I have a LaRue 12" OBR in captivity, and two stripped LaRue uppers that will be built out, one as 14.5" and one as a 16". As it stands now, the 14.5 and 16 will have the Noveske rails and a standard setup with an inforce light, handstop, Dueck Defense offset sights and an EOTech (my old eyes like the ring).

The two Geissele rails I bought will probable stay with me. I already took the a$$ chewing from the spousal unit for spending the dineros so no sense walking that ground again I'll probably put one on the LMT forgery I have, and one will go on a second LMT stripped upper.

I just need to find a few more parts and some time to do it all. I'm having a hard time finding a decent low profile gas block, go figure.

[Koshinn]

Yes, sorry I wasn't specific. The regular flash hider. Couldn't find the inner diameter of the NSR. Anybody know?

1 3/8" at the smallest cross section (straight across), 1 1/2" at the diagonals.

So I have a regular Vltor MUR and a BCM upper receiver. Is it worth going to my local gunsmith to drill it for the anti-rotation pin?

[madisonsfinest]

Has anyone found a cheaper wrench than the snap on for the barrel nut?

[Koshinn]

Has anyone found a cheaper wrench than the snap on for the barrel nut?

http://noveskerifleworks.com/cgi-bin...status=&title=

For $15 + shipping + torque wrench (which you need anyway)?

[madisonsfinest]

http://noveskerifleworks.com/cgi-bin...status=&title=

For $15 + shipping + torque wrench (which you need anyway)?

Thanks. Now I have to find one in stock! lol. The damn wrenches are even sold out during this craze!

[Brahmzy]

Wow - had no idea they finally started selling the wrenches!