The Official GLOCK Picture Thread

[Sindervhit]

Sindervhit,

That sir is an awesome stipple job. I just completely missed your picture. Thanks for the reply and that definitely gave me an idea.

-Jax

Thanks man, it's actually only the second one I've ever done, it's definitely tedious work! I simply put the laser grip on and sharpied around it, the marker lines are probably still visible.

[TMcGuff]

[Sindervhit]

Nice work, T.

[Wake27]

Finally rounding off my primary carry weapon. Installed the GFA a few days ago and just put on the base-plates and mag release. I couldn't get the slide stop yet, the damn trigger pin would not budge. A set of RB1's went on 2-3 months ago and that should be about it. I have the [I believe its called] Connector 5 from Glock that I dropped in several months ago. All that's left is to switch the trigger to a smooth one probably, and get a good light bearing holster for it. Right now I use the SKD IWB-1 which is solid and have a Crye Gun Clip in the kit bag.

[Jaykayyy]

Heres a couple of mine that i stippled and changed a couple of things on.

[gun71530]

Finally rounding off my primary carry weapon. Installed the GFA a few days ago and just put on the base-plates and mag release. I couldn't get the slide stop yet, the damn trigger pin would not budge. A set of RB1's went on 2-3 months ago and that should be about it. I have the [I believe its called] Connector 5 from Glock that I dropped in several months ago. All that's left is to switch the trigger to a smooth one probably, and get a good light bearing holster for it. Right now I use the SKD IWB-1 which is solid and have a Crye Gun Clip in the kit bag.

Wiggle the slide stop up and down while pushing on the pin.

Sent from my DROID X2 using Tapatalk 2

[Wake27]

Wiggle the slide stop up and down while pushing on the pin.

Sent from my DROID X2 using Tapatalk 2

I was trying that but still didn't even budge I don't think. I'll keep at it tomorrow. Thanks though.

[Rattlehead]

Tap rack couldn't fix this




After ~ 120k of 9mm.

Pic thread:

[hunt_ak]

Tap rack couldn't fix this

Looks stainless...whose barrel?

[vecdran]

Oh hey dere, OD green sexiness.





Flat Black upper, Mil-Spec O.D. green lower Cerakote. Gen4 slides are too slippery, so the flat black made it much grippier.