The lower is a LAR Grizzly, I'd be surprised if it was the reciever - it looked visually like the two holes lined up properly, just a bit of the trigger base higher than it should be - barely. Is there any risk that I installed the trigger incorrectly? It function checks, I don't see how I could have impacted the height of the base trigger part. It just worries me a bit as it seems like it should slide right through and I forced it in there.
As for the detent pin, too bad there are no instructions on this from PSA.
I'm with you guys, the round side should probably touch the pin which is what I was afraid of... I just thought perhaps the pointed side made sure it would hold positively and not loosen on accident, especially since it was the taller end. Still hoping to get an official answer from PSA. It makes me curious why they made their detent this way? Confusing for first timers. Maybe the pointy side is supposed to keep spring more secure? Looks like its back to youtube/brownells to figure out how to reverse the pivot pin install...
Bookmarks