AAC mount?? Rockset required or will Loctite suffice?

[adh]

I just installed an 18tooth break that I bought a while back. The Rockset it came with had hardened up already and was not usable. I had some blue Loctite handy and used that, but want to know it I need to remove and reinstall with Rockset. IIRC, the Loctite is susceptible to heat and the Rockset isn't. Do I need to get some more Rockset and remove/reinstall the mount?

Thanks for your input,

ADH

[Robb Jensen]

If you're going to use a suppressor on it use Rocksett.

[JasonM]

yeah, use Rocksett, but rather than getting it from a silencer manufacturer, you can get a life supply here: http://www.amazon.com/Flexbar-Rocksett-2-OZ/dp/B001C1D800/ref=sr_1_1?ie=UTF8&qid=1335272322&sr=8-1

[GTifosi]

As the stuff is water solulable couldn't OP just wet the hardened stuff down a bit to get it soft again then apply and let re-dry, or does water ruin its properties?

[adh]

Thanks for all the replies....gonna be running my M41000 on it with some frequency


As the stuff is water solulable couldn't OP just wet the hardened stuff down a bit to get it soft again then apply and let re-dry, or does water ruin its properties?


Unfortunately no......because the OP tossed the stuff....oh well:rolleyes:

[afroney]

Rocksett has always done the trick for me on muzzle devices.

Loctite (blue or red) will break down at higher heats.

[usmc45]

I found this to be pretty helpfull.

http://www.aacblog.com/?attachment_id=11422

[HELLABEN]

nm,,,