P2000
06-05-12, 12:34
I was doing some toolbox rearranging and found this buffer that originally came with my pre M4carbine.net lower. I decided to take it apart out of curiosity, as I knew it wasn't correct. The buffer felt solid because nothing was sliding around in there. I don't have a scale, but it feels lighter than a H buffer. It is not marked and is missing the typical 3 flat sides. It came from a circa 2005 Ameetec "M4" lower. When I bought the lower I thought M4 meant it was military grade or at least of military design...
http://i82.photobucket.com/albums/j248/87228/P6050823.jpg
http://i82.photobucket.com/albums/j248/87228/P6050829.jpg
In addition to a one piece steel weight which fit snugly inside the housing, there was a dense rubber cushion to make sure there was no sliding back and forth going on.
Thanks to this site I am now able to spot some of the nonsense going on out there.
http://i82.photobucket.com/albums/j248/87228/P6050823.jpg
http://i82.photobucket.com/albums/j248/87228/P6050829.jpg
In addition to a one piece steel weight which fit snugly inside the housing, there was a dense rubber cushion to make sure there was no sliding back and forth going on.
Thanks to this site I am now able to spot some of the nonsense going on out there.