Aimpoint mounts for HK416

[Loner]

What optic mounts are readily available for use with the HK416 to cowitness with its irons. I heard Larue Aimpoint M4 mounts are available. How about for the CompM3? T1?

[KevinB]

None I have found with the M3, the high mount is to high to use thru the Aimpoint window and the low is an upper (ish) 1/4 picture - not very good.

Same with the T1

I sent Mark Laure an email about one for the T1 as I like the fixed sight on the 10.5 (and never heard back :( )
- on the 14.5 put Troys and use a Short Dot ;)

Larry Vickers got a set of clone sights on his that are the "correct" height and he can lower 1/3rd his (if I am quoting him right from what he said)


FJB and I asked Grant to talk to ADM to see if they would consider it.

I'd like to put a Micro T1 on my 10.5 416 and use its irons

[Loner]

FJB and I asked Grant to talk to ADM to see if they would consider it.

I'd like to put a Micro T1 on my 10.5 416 and use its irons


Same here.

[FJB]

I've sent Mark LaRue an email recently asking for a Micro T-1 Mount that will work on HK416 with HK sights.

The CompM4 will work with a LaRue LT659 for HKs.

The CompM4 Aimpoint QRPII mount will work if you remove the spacer. There are two short screws in the box that are for mounting the QRPII sans spacer. The Norwegian military has their CompM4s on HK416s set up this way.

The Aimpoint QRP mount with out a Universal Spacer will work with HK416s using CompM2/M3s/C3s etc. Our new QRP mount solves a lot of complaints given to the older QRP and might prove waiting for if you want to use a CompM2/M3 with an HK416.

S/F